English French

Using the RespIn 11 Bronchial Clearance System is as simple as following the six steps below.....

 

1 - CONNECT THE RESPIN 11 UNIT TO THE MAINS SUPPLY.

  • Ensure the unit and power cord are not wet or damp.
  • Plug the power cord into the rear of the unit.
  • ONLY connect the unit to a grounded electrical outlet.

NOTE: The required power cord can change for different countries.

2 - FIT THE RESPIN WRAP.

  • A cotton t-shirt or similar clothing must be worn under the wrap.
  • Do not wear the wrap in direct contact with the skin.
  • For the best fit, inhale deeply when "wrapping" the wrap.
  • Ensure the wrap fits close to the body without being uncomfortably tight.
 

3 - CONNECT THE HOSES TO THE WRAP.

  • Connect the wrap to the hoses provided.
  • Fit the hoses using the markings shown on the handles.
  • Fit the 2 dot handle to the 2 dot connector.
  • Fit the 3 dot handle to the 3 dot connector.
  • Push and twist the connectors until the locked position.

4 - CONNECT THE HOSES TO THE RESPIN UNIT.

  • Connect the unit to the hoses from the wrap.
  • Fit the hoses using the markings shown on the handles.
  • Fit the 2 dot handle to the 2 dot connector.
  • Fit the 3 dot handle to the 3 dot connector.
  • Push and twist the connectors until the locked position.

5 - POWER ON THE RESPIN 11 UNIT.

  • Turn on the unit by using the switch located on the rear lower panel of the device.

6 - CHOOSE DESIRED OPERATING MODE.

  • Follow the on screen display to select your operating mode.

NOTE: The RespIn 11 Bronchial Clearance System MUST ONLY BE USED with a certified Doctor's prescription.  The decision on the final therapy configuration and said therapy is the responsibility of the treating qualified Clinician / Doctor / respiratory Therapist or Physical Therapist.